• To examine the heart, brain, liver, pancreas, male and female reproductive organs, and other soft tissues.
• To assess blood flow.
• To detect tumors and diagnose many forms of cancer.
• To evaluate infections.
• To assess injuries to bones and joints.

The MRI process goes through the following steps:

1. Reminders before the examination

   Tell the technologist: if you are claustrophobic and think that you will be unable to lie still while inside the scanning machine. if you have a pacemaker inserted, or have had heart valves replaced. if you have metal plates, pins, metal implants, surgical staples, or aneurysm clips. if you have permanent eye liner. if you are pregnant. if you ever had a bullet wound. if you have ever worked with metal (i.e., a metal grinder).

   A magnetic field is created and pulses of radio waves are sent from a scanner.
   
   
2. The radio waves knock the nuclei of the atoms in your body out of their normal position.
   
   
3. As the nuclei realign back into proper position, the nuclei send out radio signals.
   
   
4. These signals are received by a computer that analyzes and converts them into an image of the part of the body being examined.
   
   
5. This image appears on a viewing monitor.

How is an MRI performed?
Although each hospital may have specific protocols in place, generally, an MRI procedure follows this process:

1. Because of the strong magnetic field, the patient must remove all jewelry and metal objects such as hairpins or barrettes, hearing aids, eyeglasses, and dental pieces.
   
   
2. If a contrast medication and/or sedative is to be given by an intravenous line (IV), an IV line will be started in your hand or arm. If the contrast is to be taken by mouth, the patient will be given the contrast to swallow.
   
   
3. The patient lies on a table that slides into a tunnel in the scanner.
   
   
4. The technologist will be in another room where the scanner controls are located. However, the patient will be in constant sight of the staff through a window. Speakers inside the scanner will enable the staff to communicate with and hear the patient. The patient will have a call bell so that he/she can let the staff know if he/she has any problems during the procedure.
   
   
5. During the scanning process, a clicking noise sounds as the magnetic field is created and pulses of radio waves are sent from the scanner. The patient may be given headphones to wear to help block out the noises from the MRI scanner and hear any messages or instructions from the technologist.
   
   
6. It is very important that the patient remain very still during the examination.
   
   
7. At intervals, the patient may be instructed to hold his/her breath, or to not breathe, for a few seconds, depending on the body part being examined. The patient will then be told when he/she can breathe. The patient should not have to hold his/her breath for longer than a few seconds, so this should not be uncomfortable.
   
   
8. The technologist will be watching the patient at all times and will be in constant communication.